Voice Systems and Accessories - Small Business

Hello all, new to this community looks very vibrant.I have had a UC520 based deployment for a few years but haven't really set it up and now I am trying to set it up and I had a couple of questions.#0 Does it make sense to even deploy a UC520 in 2012...

Hye All,I have a 7942g phone. it's IP configuration is static and it has to register on a UC540 that has a capacity of 40 ephones.Right now, 14 phones are registered on this equipment but when i wish to add any other phone, it mentionsregistration re...

Good evening all,I have setup a UC320 with 4  FXO lines and we need to have a disaster recovery plan put in place (in case the UC320 dies or we have a power failure).Here is my current setup:4 FXO lines1 FXS that is actually my doorbellI have run 4 l...

Any way to upload additional ringers to the 525G2 phones either on a per phone basis or system wide?  The choices provided with the exception of the "office" ringer seem rather corny and not professional.

Hye All,I have a 7942g phone. it's IP configuration is static and it has to register on a UC540 that has a capacity of 40 ephones.Right now, 14 phones are registered on this equipment but when i wish to add any other phone, it mentions registration r...

Is it possible to have either a softkey or replace a line button with an Extension Mobility logon button?Our customer has UC560 (CME 8.1) with SPA504G handsets.Thanks in advanceMatty

I am having a problem with my IP Phone 525g which is getting worse and I really need some help to figure out: its only on my device or a know issue.Here is the problem I have:Early on, I've realized if I set my Bluetooth configuration to both(handsfr...

Hi All,I was wondering if anyone could shed some light on this problem.I have 80+ SPA942 phones running on a 3CX v10.0  SoftPBX system and have had no problems so far.I was tasked with supplying some new phone but keeping withing the Linksys/ Cisco f...

Hi, Anyone successfully gotten a SPA2102 to register to the Unified Call Manager.I am currently using UCM 7.1.3. Thanks a lotRegardsJackson

HiAnybody aware of if we can program UC320W for a Single number Mapping (With PSTN Lines) and or VoIP lines

Hi,I am using UC540. I have 3 blast groups created which has three different DID numbers assigned to it. How can I set up a callerID for each of these 3 blast groups. For example, if a user from a prticular blast group dials out his outgoing number a...