Voice Systems and Accessories - Small Business

Hi All,It has been an interesting week, with the release of CCA 3.1, SWP-8.2 and OM 2.0 all released at the same time, we certainly were spoilt.Well over the last couple of days and on the weekend, I spent some time reviewing OM version 2.0 just rece...

Hello everyone,I'm planning on setting up a UC320W for use with several SPA 525G2 phones. We currently have phone service through Vonage (2 lines, but will have 5 soon). Is it possible to run the Vonage service straight from the UC320W? Has anyone tr...

Hi Cisco Team,Firstly let me just congratulate you on the release of CCA 3.1 and what a FINE release it is So let the fun begin...Was bored on the weekend so I decided to give this thing a good once over, and finished it of this morning by checking i...

Hi guys,is 2 days trying to get my SPA3102 but I can not. Let me explain better my situation. I bought an SPA3102, my requirement is to remote my telecom phone line to use it even in my home is equipped with a secondary connection to the Internet. I ...

Hi,Can the SPA525G2 please allow 1 call appearance per line (instead of minimum 2)?This then replicates the behavior of all the other phones in the 5xx line.It is very disconcerting to users to have multiple calls come in on the same line key.Thanks....

I'm looking for a way for the IP Communicator to be used when traveling and assume the identy of the persons office phone including extensin, VM, etc.  Is Extension Mobility the way to do that?  The Office Phone will be a SPA504 or 525G2.

HINot sre if this is correct, im using voice only topology, and i have 3 spa phones plugged directly into the uc320w, the dhcp for Data is on a windows server, now when i have a look at the network settings in the phone i see that the vlan id is 1, s...

  Hi all,Trying to setup my very first UC540. I have a problem with the voice mail and AutoAttendant. When I dial it it says enter my extension followed by "pound sign" I enter this and it just keeps asking "are you there?"I have all the latest versi...

Can anyone assist me in getting CCA to find my UC540wI think I may need to change the ip address of the telephone system from a 172 address to a 10.15 address and not sure of the implications or whether this will enable CCA to work.Can anyone advise?

So historically we've always done all our configurations via CLI.  Up until recently when the CCA started to become a useful tool..  the problem is all of our configurations were done as 'normal lines'  meaning we'd have more than one ephone with the...

Hi,I've found this page on my UC540. What is this Cisco Configuration Center Handshake?I searched on the web but I haven't found anything on this "feature"?Thanks

Hi everybody,I would like to configure the UC500 to display, for all the outbound call, part of the entire company number.We have a lot of number with the same prefix (i.e. 2222101 - 2222102 - 2222103 and so on..) and I would like to prune the numer ...

The exiting of CCA version 3.0(1) requires a minimum of three operations, specifically:1) Pressing the "Red X" to close the form.2) Confirming that I really want to exit the application.3) Asking if I want to save the configuration even after I just ...

Team,I have a uc520 that is running CM 8.1 with 15.1(2)t2 but the voicemail on it is 2.3.4.Each time I try to upgrade it using configuration assistant it fails. My guess is because it is so old it may have to first be upgraded to some interim version...