Voice Systems and Accessories - Small Business

I've been beating my head over this and can't figure out what could be wrong.  Hope someone can help me out.  Here's the network layout:Internet - Cable Modem - 192.168.1.1 Wireless Router - 192.168.1.2 UC520 192.168.10.1I can't get calls in or out a...

Hi, I'm new on phone systems. I installed uc540fxo and spa525g and spa504g's in PBX mode. Everything works good. But i need to monitor all fxo lines which is used or vacant on the phones and I need to take a line when I press that button without pres...

Would like to connect up our 3rd party cti software to a clients UC500 - however local supplier is very vague on what interface is needed on the UC500 toenable this. Any advices on what is required are appreciated.

     Hi,I have problem with cisco UC 540's ssl vpn. I set up ssl vpn via VPN wizard and send one spa525g to another city. The vpn connects and we can speak up to 1.30 min. and the other side cannot hear me again. But I can hear the other side's voice...

We've got a SPA2102 installed behind a client's very, very restrictive firewall.    They block all outgoing ports by default.We've had them add rules to allow SIP traffic on 5060 and the default RTP port range of 16384 to 16482.This all works just pe...

I have put much effort into trying to find out how to configure my SPA3102 so it will forward certain PSTN numbers to my VoIP number to no avail so far. Any help with this is appreciated. My goal is to have the SPA3102 read the caller ID on incoming...

I have a UC520 in a small business with 6 phones.  2 people left the company and I wanted to record a new *.wav file to use for phone extension help on button 3.  I am using 1 auto attendant with a *.wav file to announce which buttons to use to get t...

Hi,I am using SPA504G and the blind transfer using ## + * {extension} works without any issue.Its just that I dont know how to use the bXfer feature on this phone. I also have 1 expansion module SPA5000S attached to this phone. I have added following...

I am trying to work with a SMTP server that uses the default-from email address as authentication.  This is for a UC540.  I tried logging into the CUE CLI and typed the following commands:ccn subsystem emaildefault-from customer25@abccomany.com endIt...

I have purchased the SPA-3102 in order to make available a pots line from the VOIP network.  The system we are using is the NEC IPK II Electra Elite.  I have two sip client licenses. I have set up the SPA-3102 to connect to the CPU IP address of the ...

When I call out using a cordless phone plugged into an FXS port I can seam to use the tones after the call is placed.It makes it difficult to call company's and use there automated phone systems.Are there any solutions for this?

After upgrading my UC520 to software pack 8.1.0 my SPA525g only has the black boxes at the bottom of the screen. No letters/words.Any Ideas?Running 7.4.6Thanks!