Voice Systems and Accessories - Small Business

i am new to this integration.i have configured the exchange server and enabled the unified messaging.(created the dialplan,IP gateway,UM policy on exchange server)in the uc 500 i have applied the following.dial-peer voice 550 voipdescription ** Excha...

Hello,With my clients UC560 they need to dial a prefix for outbound calls ("0").  Their Outlook contacts do not have a preceding zero and when you select a contact in Outlook it places the contact's number in the toolbar perfectly, but there is no pr...

Hi,I am using these phones with a UC540. The date in call history log is not correctly displayed. I am trying to access the phone admin page to make some configuration changes. Why cannot I edit any of the fields? I am using http://phoneipaddress/adm...

Hi all.I am in Spain at the moment and trying to set up a SPA3102 so that I can make VOIP calls (using freecall.com) but also be able to make PSTN calls from the same phone. What I ideally want is to be able to use the PSTN line for national calls, a...

Dear Sirs,we use few cisco spa509 and one spa525g with 3cx PBX. All settings we submit through autoprovisioning with auto-resync timer in 24hrs.Today spa525g starts to update .xml file every 10 to 40 seconds. It looks like - make unregistered all lin...

ok here is my set upcable modem ip 173.163.87.166 one wire to adtran 4305 router eth 0/2 ip 173.163.87.165 second wire from cable modem to uc 520 wan port 173.163.87.161the adtran is the main router for the data lan eth 0/1 ip 192.168.1.5the voice ne...

Hi,Hi,I have a UC540 configured with a Skype sip trunk. The trunk is registered with Skype. I'm unable to make outgoing calls. I configured the trunk using the latest version of CCA and followed and updated PDF doc for the Skype config. Incomning cal...

When I did a software upgrade using the CCA, it failed when it was restoring the CUE data.  Afterwards, when you tried to access a mailbox, it acted like all mailboxes were new.  I backed up the system before the upgrade so I did a restore.  It resto...

Using the CCA 2.2.6 , i'm trying to find a way to lock down a phone that is used in an unsupervised area.  Basically it needs to dial 911 for emergencies and if possible enter a PIN to get an outside line.Any suggestions....

We have a customer with a UC520 than randomly rebooted.  It only happened once so far.  Are there any error logs I can check to find out why it rebooted?I noticed the closet that stores the UC520 is pretty hot.  That might be why it rebooted but I ca...

Any information or design guide for new Cisco Smart CallConnector Operator. Is it supported for Callmanager Express?http://www.cisco.com/en/US/prod/collateral/voicesw/ps6882/ps10585/data_sheet_c78-568488.htmlwill it be supported for configuration thr...

After three weeks of brutal agony, a solution....Problem: outbound calls from UC540, all SPA525G2 phones through carrier using Metaswitch failed to pass DTMF to PSTN.Metaswitch published two different config guidelines around the UC500.  The Doc ID 9...

Hi all, hope if you can help me. I have a CME with ios Version 15.1(1)T2, RELEASE SOFTWARE (fc1).I already check everything and I can't find the problem.I have a BRI configuration like this:************************************************************...