Voice Systems and Accessories - Small Business

Hello,I had no success provisioning the router configuration with the firmware v2.00.05 with the same XML file I provision the version v1.01.00. The voice part is configured (<flat-profile>), not the router part (<router-configuration>).Syslog shows ...

I'm trying to get the outgoing Caller-ID Name to work with Skype for SIP.  I changed the pstn-to-sip under sip-ua, but it still shows Private when I place an outbound call.  I'm want the company name to show.  It worked with another SIP provider so I...

Hello,I'm looking for French Voicemail Prompts for my Linksys SPA400. I have contacted the reseller (Amazon.com) that I have purchased the device with but they are unwilling to help me. So if Cisco could help me obtain it, that would be nice.Thank yo...

Has anyone else had issues with RSS feeds on the SPA-962 (6.1.5(a)) ?The first 1 or 2 feeds I select after the phone boots come up OK but then I can't switch to another feed - it just hangs at 'Updating news feed data...'. It doesn't seem to be a pro...

When dialing digits while in a call (e.g. connected to an IVR) the phone sends DTMF but the dialed digits are not shown on the display of the phone.Is there a way to enable that function?

we just bought spa8800 series gateway 4fxs with 4 fxo port. And found there is no option to set NAT mapping enable "No" however does allow to set for Phone 1 but for other lines its "Yes" by default and does not allow to set.We did try to disable by ...

I need to assign a static IP address to a SPA508g phone.  We have multiple locations and Our President wants a phone in one of our remote locations connected to our Headquarters.  All of our sites are connected via 2600 routers over an MPLS.  I have ...

Is this the only way non-business users can get support? There are a number of issues I need to report to Cisco which would help them improve their products but seems I would have to pay a fortune in order to do so... is there any other way that retu...

Does UC 540 support Primary NI2?

I have a 509G in SIP on asterisk (trixbox). Is it possible to create a button that will blind transfer to an extension? I am basically looking to make a one touch park button. The user would hit it and the phone would initiate a blind transfer to ext...

<Idle_Key_List ua="na">resume|1;psk1|2;dir|3;redial;lcr</Idle_Key_List>Identical config works on SPA525 and amazingly it also works on a 502G

HII am installing a UC560 into an office with 24 extensions they want to have a common address books that when a call comes in, the Persons Name apprears on the 79** phones rather than their number They had a similar system with  alcatel where each e...