Voice Systems and Accessories - Small Business

Hi,I am uisng a Cisco ATA-186 version 3.02.01(050616A) box and i want to change the Domain name.Does anyone know how i can do this ?At the moment that field is empty.When i try to register the ATA box to a SIP proxy server,the SIP proxy requests auth...

So we are contemplating rolling out SPA 9000 with two SPA 400 one for VM and one for PSTN...however, I'd prefer to use SIP trunks via the ITSP. Which providers can i contact for this service on this platform? In addition, are the SPA9x series the onl...

Several of the ringtones packaged with the 8.0.0 and 8.0.1 software releases sound awful compared to the ones included in the 7.1.3 release.  They pop and cutoff and have a bad echo.I don't think this is a terrible issue by any stretch of the imagina...

Hi Guys,I think I must have downloaded every available file from the Cico web site, however to no avail.Could someone please assist me with what file I requier to change the region and vmail setting language to UK - GB....I am running the UC520 8.0.0...

I have tried everything mentioned in this thread (https://www.myciscocommunity.com/thread/3591), but nothing is working. Is there a way to reset the user/apss for the web user/pass in CME and re-sync to CUE?GUI commands are correct, path is there, UC...

Can someone provide me with UC520 install/upgrade guides as well as the admin guide? I've followed the links as I normally do and am not seeing anything out there... Thanks in advance.*updated*Also, during the build out, I'm not seeing the option to ...

Just wondering if in those scenarios SPA should start disconnect tone  detection and release FXO? 1. PSTN -> FXO[SPA]IP -> IP[SPA]Line1 PSTN drops the call 2. PSTN -> FXO[SPA]Line1 PSTN drops the call Thanks

Hi,in my company we use static ip's for the pc's.now i configured the uc520I've  deleted the dhcp pool vlan1 and give the interface vlan1 the ip 192.168.115.253 255.255.255.0then i configured in the global config mode   ip default-gateway 192.168.115...

Hello Guys,i have a small issue,when i try to make my SPA run with my 3CX PBX for inbound faxing i always have this issue after the reinvite to t38:SIP/2.0 488 Not Acceptable HereRFC:21.4.26 488 Not Acceptable HereThe response has the same meaning as...

Hello!There are several questions regarding SPA8000, firmware 6.1.3Ports 1, 2, 3, 4 are in trunk with numbers 101-104.1) Is it possible to transfer incoming call from one port to another port in trunk?2) Is it possible to call from one port to anothe...

I'm trying to get Communicator to work with CUVA, but the Video icon is not showing up in Communicator. I've logged into CCME and ensured that video was enabled in Communicator. Any help would be greatly appreciated.