Busy signal with incoming calls.

[mcastilla]

Hi all, I have a problem with the incoming calls. I hear only one tone and the next a busy signal. I don't know if the configuration is correct, the outgoing calls working fine.

Many thanks for all.

Best Regards.

M.Castilla

[Steven Smith · Accepted solution]

This community is for Cisco Small Business products such as the UC500, not the 1700.

Looking at the config, I see no inbound dial peers or routing for the inbound dial peers. 

These might help.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010ae1c.shtml

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

If you still need help, I would recommend the netpro forums.

www.cisco.com/go/netpro/