Caller ID showing A0

[mahesh101]

Hi

I set up A UC520 with the software (8.0) and latest CCA 2.2(5). Calls were routed on FXO port to Co-line and caller ID was shown however after upgrading to the latest firmware (8.1) and software(CCA 3.0) when a call comes in the caller ID shows up as A0 instead of the caller's phone number, I have enabled caller-ID on the FXO port by using CLI however this has not worked. I previously used the following code to enable caller ID on the system :

voice-port 0/1/0

shut

cptone GB

timing sup-disconnect 85

impedance complex3

caller-id enable

caller-id alerting line-reversal

caller-id alerting dsp-pre-allocate

no shut

exit

However this code is not accepted in the new firmware.

Do you have any suggestions?

Regards

Mahesh

[mahesh101]

Any Update on the Issue mentioned above

Regards

Mahesh

[mahesh101]

Hi

Reset and retried code and worked - CallerID now working

Regards

Mahesh