Configuration of 2 ISP with UC540

[ppaul]

Hi

I have two ISP. I would like to configure the UC540 to handle both the ISP. At present one ISP is connected to the WAN Port. We have converted one of the LAN port into a WAN port and connected it to the second ISP. How do I make 1 VLAN traffic to route over ISP 1 and the other VLAN traffic over ISP2.

- Peter

[paolo bevilacqua]

With Policy Routing:

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a008009481d.shtml

[dominic lazure]

how did you convert a lan port into a wan port?

i am trying to figure how to connect my sip trunk and my internet connection ( 2 routers ) if there is only 1 wan port....

thx

[danplacek]

This could be done in CCA by adding a VLAN then assigning it to one of the LAN ports as an access port to that VLAN.

This is done under:

Switching -> VLANs

and

Switching -> Smartports