Hello all,
A customer of us wants to expand there isdn lines. A patton smartnode has been ordered en configured for this.
I don't get it managed to work with the uc520.
The gateway is configured to pass-through everything 1 on 1 to the uc520.
Below the configuration of the dial peers of it:
dial-peer voice 6001 voip
description outgoing dial-peer via ISDN GW National
preference 3
destination-pattern 0[123456789]T
voice-class codec 1
voice-class sip dtmf-relay force rtp-nte
session protocol sipv2
session target ipv4:10.1.1.100:5060
dtmf-relay rtp-nte
ip qos dscp cs5 media
ip qos dscp cs4 signaling
clid network-number 454040000
no vad
!
dial-peer voice 6002 voip
description outgoing dial-peer via ISDN GW International
preference 3
destination-pattern 00[123456789]T
voice-class codec 1
voice-class sip dtmf-relay force rtp-nte
session protocol sipv2
session target ipv4:10.1.1.100:5060
dtmf-relay rtp-nte
ip qos dscp cs5 media
ip qos dscp cs4 signaling
clid network-number 454040000
no vad
The dial peers for the isdn ports on the uc520 are working fine. They are configured with preference 1.The uc520 and smartnode can reach eachother.
Only when the 4 isdn lines of the uc520 are busy and the 5th line comes in then the call doesn't enter the uc520. So i think i miss something in the configuration?
Can someone tell me how to configure it?
Thx in advance,
Best regards
Mitch Rouwette
