08-12-2014 03:46 AM - edited 03-21-2019 10:18 AM
I want to connect two SPA8000 voip gateways.
Is that possible to do? if it is possible how to configure these devices?
08-12-2014 09:33 AM
Hi,
I did some research and found the best way to use these devices would be to assign an static IP address to each one and connect them to a switch.
Regards,
Tere.
Please rate if helpful!
12-07-2015 09:22 PM
I am trying to do the same thing but unfortunately connecting to a switch and setting static IP addresses only gets them talking on the network. A little more information on how to set up both ends of the link would be helpful. I have five analog phone lines connected at the office end of the network and five analog phones at the remote site to be extended. If you have any settings suggestions that would be appreciated.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: