Default Access Code - Initial Config

[Joseph Chambers]

UC540

8.0.4 using CCA 2.2.5

During initial wizard, I specified Access Code to be "8".

After install is complete, I can't make calls out with either 8 nor 9.

I went into Dial Plan, Outgoing and it shows my default access code as 8, however the Outgoing Numbers Access Code are still showing 9.

Of course, I was able to change them to 8, BUT, what's the point of asking for my Default Access Code, if you aren't going to change the Access Code in the Dial Plan?

I've Factory reset this unit 2x and it has been this way both times.

[Scott Martin]

Hi Joe,

What country dial-plan are you loading?  I did this with the Australian dial-plan, and had no issue setting the access digit to '0' - as is common here.

This could be an issue with the country-specific dial-plan?

Cheers,

Scott Martin

SMARTINET

[Joseph Chambers]

North American