cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
915
Views
0
Helpful
7
Replies

External Conference calls failing

tekworksinc
Level 1
Level 1

Installed a UC560 at a customer site with a SIP connection to a COX Edgewater. Incoming and outgoing calls are working but having trouble with conference calls. Conference calls work internally but when you try to conference in an external caller the call fails.

Any help would be greatly appreicated.

1 Accepted Solution

Accepted Solutions

Could you please share the output of "show dspfarm profile".

Also please double check if the codec is g711ulaw. Debug ccsip messages and debug ccsip media, and debug voip ccapi inout should tell you if the codec is 711ulaw.

You may have setup g711ulaw but something may have changed in the config.

Best regards,

Alex

View solution in original post

7 Replies 7

Hello Tim,

You should check if you have the conference set with different codecs if you are using g729 for the sip trunk.

HTH,

Alex

*Please rate helpful posts

Hi Alex,

g711u is being used on the SIP trunk.

Hi Tim,

What is the type of the conference ad-hoc(you call the other participants) or meet me(participant calls a specific number) that you are trying to get working?

If you are using CCA just enable the hardware conferencing.

how many participants you are trying to add to the conference and wha is the type of the phone?

Could you please share the output of "show dspfarm profile".

Best regards,

Alex

The type of conference is ad-hoc. Calls fail when trying to add one external participant. The type of phones are SPA514G.

sccp local Vlan90

sccp ccm 10.3.10.1 identifier 1 version 4.0

sccp

!

sccp ccm group 1

associate ccm 1 priority 1

associate profile 1 register confprof1

!

dspfarm profile 1 conference 

description DO NOT MODIFY, active CCA conference profile - CCA2.0 codec711

codec g711ulaw

codec g711alaw

maximum conference-participants 32

maximum sessions 2

associate application SCCP

!

Could you please share the output of "show dspfarm profile".

Also please double check if the codec is g711ulaw. Debug ccsip messages and debug ccsip media, and debug voip ccapi inout should tell you if the codec is 711ulaw.

You may have setup g711ulaw but something may have changed in the config.

Best regards,

Alex

What exactly do you mean the call "fails"; re-order tone, doesn't ring out, ...?

Can you provide the output of "debug ccsip mess" while attempting a conference?

Codec issue, everything is good now. Thanks