04-21-2011 03:36 AM - edited 03-21-2019 03:59 AM
Hi,
How do i configure on a UC560 Fax2Email with a SIP Trunk and T.38 like T.37 Fax to Mail with CCA?
Best regards,
Thomas
04-21-2011 05:30 AM
Not supported on the UC500. Fax to email is only supported on PSTN connections.
Adam Compton
04-21-2011 05:37 AM
Hi,
I know that it is not supported and can't be configured with CCA, but it should be possible to configure Fax over IP with CLI.
How can i configure Fax over IP with CLI on a UC560?
Best regards,
Thomas
04-21-2011 05:49 AM
Faxing over SIP trunks can work if it is going to an FXS port. Fax to email is a different story. The TCL script used for fax to email can only use POTS dial-peers, thus not allowing SIP trunks fax to email.
Adam Compton
04-21-2011 06:42 AM
Is it enough to configure DID for a number and point it to an internal extension of a FXS port?
Would it then also be possible to send a fax?
What has to be configured for Fax to Email with a SIP trunk on a UC560 with CCA default settings?
Thomas
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: