cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
929
Views
0
Helpful
1
Replies

I think I found the answer to all my SPA9000/400 problems

William Paulsen
Level 1
Level 1

The answer is this: This product pair is apparently past it's End-Of-Life.  My reasoning is that there has not been a new firmware release for about 1.5 years.


Why do I care?  Because it's time to give up with this product and this forum, and move on to find a replacement IPBX, which is unfortunate since this setup is less than 2 months old and I spent too much time with all the bugs.

1 Reply 1

jhclemente
Level 1
Level 1

Unfortunately, you are right.


I don't know why cisco stills prommoting selling this equipment if they are not supporting them anymore.

I'm in Mexico and I purchased them about 3 months ago, after a presentation they invited me to assist, they worked very well on the demo but now I'm having a lot of problems.

Does anyone know a good replacement for them?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: