cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1050
Views
0
Helpful
5
Replies

Input gain for SPA504g

j.eggen
Level 1
Level 1

I am trying to figure out how to set my input gain for my SPA504g phones.  I was able to view the phone's website and can see the settings listed there, but can't seem to get into an admin mode.  using the http://phoneip/admin just shows the same page as the http://phoneip site.  Do I need to somehow enable the admin mode to make these changes or can I change these settings on the phone itself?

5 Replies 5

Rick Thomas
Level 1
Level 1

John, are you using your Cisco SPA504G

with a VoIP service provider, or with your own IP PBX?

j.eggen
Level 1
Level 1

I have my own IP PBX - Cisco UC560

ericdolton
Level 1
Level 1

Any progress on this?  I am having the same issue trying to make changes

via the web interface

No luck yet.  Someone mentioned that you have to enable the admin settings on the default XML file for the phone.  I am the admin for our phones and UC560 system but have not figured out how to do that.  If I knew how I have the credentials to do it, just not the knowledge!  (I know, that can be a dangerous position to be in.)

bagattij81
Level 1
Level 1

im on the phone with the SBSC about this very issue, i think its rather ridiculous that this Cisco has not replied to this question.