cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
647
Views
0
Helpful
1
Replies

interface between UC and fire system

jzientek83
Level 1
Level 1

Hello,

We are trying to find a way to dial an extension number on our Cisco VoIP phones, that would enable the interface on our firelight alarm system.

In the old days it was just a plc interface that you could change some logic.

The company of the alarm system states that they only need an acknowledgment signal to activate a relay.

Is there a module that can go between a phone or UC system and the firesystem that anyone knows about.

There also maybe another way to do this and if anyone knows a good way, please let me know.

Thank you very much,

Jim

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Ask the alarm company what is the interface device the use with other customer PBXs.

Buy and connect it to an FXS port.

If they can't indicate one, get something like a door opener.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: