10-23-2011 07:00 PM - edited 03-21-2019 04:50 AM
Is it possible to establish SIP communication between two or more UC300 systems without the need of a SIP Proxy? If possible, please tell me how.
10-24-2011 12:39 PM
It is. Cisco does not officially support it... but it works... sortof.
I have tested it and 2 systems do not have any trouble calling eachother... but the dialplan is a bit odd. The 320 does not like dialing 3 digit external numbers.
Setting it up is as simple as adding a sip trunk on both devices that just point to eachother. No authentication. The hardest part is figuring out the dialing, if I recall, simply dialing a steering digit plus an extension number does NOT work for dialing phones on the other system.
I really wish Cisco would do something with this... its like 90% there... some small changes would allow full site->site sip calling without the limitations....
10-25-2011 03:28 PM
Actually if they could allow us to make custom Dial-Plans you could pretty much work it out and make it work
Although the maximum amount of sites talking back to a master system would be 2 (3 all up) which is not bad, but they could enable Site-2-Site and allow for up to 5-10 site to communicate.
An Ideal solution and Could have sold this scenario at least 10 times over already, they never had the budget for a UC-500 because their business was not big enough, and the UC-320 was ideal just lacking the ability.
Ended up getting beaten by an Asterisk system using IAX to communicate between sites, on a cost-for-cost comparison the Asterisk system actually comes out dearer, insane really.
Cheers,
David.
06-05-2012 09:01 PM
Could you please explain how to do it?
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide