07-01-2013 09:17 PM - edited 03-21-2019 07:31 AM
My phone just started failing today. I have a Cisco SPA525G VOIP phone. The lights on the right of the display are all flashing amber. When I reboot, it tries to acquire an IP Address. It says the network is ok, but after a period ot time trying to get the IPAddress via DHCP, it shows a quick message that DHCP failed.
The DHCP server is running. The phone is plugged into the sasme hub as my laptiop, so the hub ans well as access to the network both work. My soft keys show up, but no dial tone and I have the blinking lights.
How do I debug this kind of issue?
07-02-2013 03:49 AM
Wrong forum, post in "small business voice - SPA phones". You can move your post using the actions panel on the right.
07-02-2013 09:06 AM
This issue has been resolved. It turned out to be a bad port on the switch so it did not have ethernet connectivity, even though the phone indicated the ethernet was ok during the reboot process.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide