The pap2t doen´s work anyway...the light in the telefon line doen´t turn on...even if I restore the factory settings. I can go in hte system and change the settings but there not way to make this line 1 neither line 2 to turn on....
Phone1 and Phone2 LED's will light only when line is active (meaning your PAP2T is registered at VoIP server).
Are you trying to use PAP2T with local SIP server or at IP Telephony Service Provider network? Could problem be that your PAP2T is residing inside your local network (NAT) and unable to reach IPTSP? What is Registration State of your Line1 at PAP2T initial (Info) screen
I´m using that with SIP server and I have already add the port 5060-5061 USD and 53 and so on has it standing in the manual.I did try to avoid to use my router and put the PAP2t directly in communication with the modem.
exactly the pap writes cannot reach the server...even if the setting are the same inn the SIP service (messagenet.it ) website and work correctly in my earlier linksys Wrt54g (worked since 3 years ago).
I tried many times that I don´t really know what to try further.