Hi Everyone,
I am very new to the IP phone world and am pretty much trying to figure how it all works.
I'm trying to set up a few SPA508G and am having some trouble.
I currently have 4 land lines and am trying to set up the phones so that i have the following:
ext2 button to represent land line 1
ext3 button to represent land line 2
ext4 button to represent land line 3
ext5 button to represent land line 4
I want to be able to have all phones see a ext light up when the line is in use or a call is coming in.
I also want to be able to put a call on one of these ext buttons on hold an pick it up from another phone with a push of that ext button.
Any assistance would be greatly appreciated. Again, I'm very new with all of this so please provide step by step instruction if possible.
Many thanks in advance.
BTW, I'm running 3cx with a Patton 4114 fxo gateway.