Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
358
Views
0
Helpful
1
Replies

SPA 112 Does Not Recieve Calls After a While

boraunal1
Level 1
Level 1

‎10-19-2015 05:26 AM - edited ‎03-21-2019 10:29 AM

Hi using SPA112.

Device stops responding the calls (I see that the Line1 is registered) after a while.

 

Unless I do a Factory Reset for voice setup, device does not respond to calls (phone does not ring and the calling party receives busy tone) but I can make outgoing calls.

Current FW is 1.3.5. I already tried to use 1.4.0 but did not fixed anything.

Any suggestions?

Best,

0 Helpful
1 Reply 1

Jaime Valencia
Cisco Employee
Cisco Employee

‎10-19-2015 10:56 AM

SPAs are supported in the SMB community, I suggest you move this over there.

HTH

java

if this helps, please rate
0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents