SPA504AG - Skype VoiP and Cisco Linksys RV 082

[Richard Benfatto]

SPA504G - Skype VoiP and Cisco Linksys RV 082Have been traying to make the SPA 504G work behing NAT with the RV082.

I have audio one way only. Call establishes and then I can speak but I cannot hear the other end.

Any ideas as to what settings am I missing? Default SPA504G RTY ports starts in the 16,000's so this may have to be changed and RTC RTCP forwarder to the internal phone in the RV 082?

Thanks

[nseto]

The phone has the NAT Support Parameters located in teh SIP tab.  You can adjust the VIA info there and set STUN server if using a STUN server, or set the EXT IP parameter to the router IP adddress.  The NAT mapping enable is in the Ext tab under NAT settings there.   Refer to the admin guide for the info on each parameter.

[Richard Benfatto]

Good morning, do not have your name but thanks !

There is now more to it. Last night I decided to connect the phone directly to the Internet as to get a public IP with no NAT.

I was able to call someone and have perfectly well two way audio BUT the person when trying to call me said :" I get a ring tone once and then defaults to busy tone". I never get the ring, in summary I cannot rreceive calls and now there is no NAT whatsoever........................ I am really puzzled.

I may need to get the Admin guide. The box came with a CD ROM and some papers but there is no (at least I cannot find it) a technical manual with every setting and what it means.

Thanks again !