Hello
Some question
On the UC500 serie's there is een "EXPANSION" port
How the configure best ?
I have in my network a few SLM2008 cisco switches with vlan support
I have a SLM2008 in my livingroom
one in the storage room (where the UC520 and the cable modem is placed)
one in the office
for digital tv i neet to have a direct connection to my cable modem > decoder so this is on VLAN 50
there is een TRUNK between the livingroom - storage room - office
in the trunk vlan1, 10, 50 and 100
how do i configure best the port in my storage room where the expoansion port is connected ? witch vlans ? tagged ? or not ?
how do i configure the best the ports where my phone's are on connected ?in the office
the UC520 is set on default so vlan 1 and 100
only in my office i don't get the phone's registered
Any advise ?