cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1851
Views
5
Helpful
1
Replies

UC 560 How do you block outbound Caller ID?

dirproservices
Level 1
Level 1

I just installed my first UC 560 system on two PRI lines from Telepacific. My client wants to block outbound Caller ID. They would like those they call to get "Unknown Caller" or similar when they call out. I am using CCA 2.2.5 to configure the UC 560. Telepacific is blocking the Caller ID but says the UC 560 is overriding the block.

So, how do I prevent the UC 560 from sending out Caller ID information automatically? Is this possible in CCA?

Thanks

1 Accepted Solution

Accepted Solutions

Darren DeCroock
Level 4
Level 4


Can't do this though CCA...

CLI:

Conf t

dial-peer voice xxx pots   <--- xxx = dial-peer number.

clid strip

clid strip name

You will need to do this on all of your outgoing PRI dial-peers.

View solution in original post

1 Reply 1

Darren DeCroock
Level 4
Level 4


Can't do this though CCA...

CLI:

Conf t

dial-peer voice xxx pots   <--- xxx = dial-peer number.

clid strip

clid strip name

You will need to do this on all of your outgoing PRI dial-peers.