UC500 and SPA500 BLF behavior

[eseifer]

Hello,

My question is in regards to BLF behavior on the SPA500 series phones running firmware version 7.4.3.

The phones are registered to the UC560 via SCCP.

Behavior:

When BLF is configured via CCA 2.2.4 for WATCH or MONITOR, the tri-color buttons are un-lit when the watched/monitored line/phone is not in use. When the watched/monitored line/phone goes off-hook the tri-color button displays red.

Question:

Can SPA phones (fw ver. 7.4.3)  registered to the UC560 (8.0.2) via SCCP have their tri-color buttons do the following?

     Be GREEN = line is registered. (This includes the phone's own lines)

     Be ORANGE = watched/monitored line registation error

     Be blinking RED = watched/monitored line ringing

     Be solid RED = watched/monitored line in use

NOTE: This requested behavior matches SPA500 phones running 7.4.4 and SIP registered to 3rd party Softswitch.

Thanks for your time.

[antyeung · Accepted solution]

I'll take a look at this and get back to you.

-Anthony

[antyeung]

I just spoke w/ our BU and currently this is not possible when the phone is registered using SCCP.

-Anthony

[eseifer]

Thanks Anthony for getting back to me on this.