UC540 connecting to PA system

SteveOrfanos · ‎06-28-2011

Hi all,

We have a customer who has an existing UC540 and would like to purchase a PA system to interface into UC540. Can anyone recommend a particular model that interfaces seemlessly (FXS ports). Customer is located in Australia.

Many Thanks

Nathan Compton · ‎06-28-2011

I'm a big fan of Valcom. I know of the V-2003 which is a 3-zone paging system, but they have a single zone page system as well. I've used their technical support before, and they are top notch.

I know Bogen's TAMB will make a FXS work with just about any paging system you can think of.

Adam Compton

David Trad · ‎06-28-2011

Hi Steve,

I Hope this helps you out

Check out my post HERE on it...

This is mainly an Australian solution but could be useful to others abroad.

Cheers,

David.

Cheers, David Trad. **When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *