12-02-2015 08:02 AM - edited 03-21-2019 08:49 AM
Hi all,
If my UC560 is configured using CCA and then I want to make changes using CLI( assuming that CCA is not available on laptop) , is that supported?
Regards
Sriram
12-02-2015 08:13 AM
Just so your aware if you make changes to a UC500 by cli TAC will not support it anymore if theres an issue
12-02-2015 08:21 AM
Hi Mark,
Thankyou for the answer. This is exactly what I was looking for as i did not see a recent thread on this support.
To do remote configuration can I enable it through CCA for the VPN?
Regards
Sriram
12-02-2015 08:29 AM
Hey yes you should be able to
https://supportforums.cisco.com/discussion/11095896/remote-access-cca-30-and-uc500-system
12-02-2015 09:52 AM
Thankyou for the quick response Mark.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide