cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1029
Views
0
Helpful
1
Replies

525G2 and Plantronics CS-540

thegiant
Level 1
Level 1

I'm a hobbyist. I use my Cisco 525G2 with a small private Asterisk server.

I'm trying to configure a Plantronics CS-540 with APC-45 cable to work with my phone.

I have enabled Electronic HookSwitch in the settings on the phone.

I can't get the headset to work. I mean, I can't get it to communicate with the phone. Pressing the button on the headset I hear the click but it doesn't seem to communicate with the phone and activate the HookSwitch, same in reverse, I press the headset button and it doesn't activate the headset. I get no dial tone.

 

I must be doing something wrong? Maybe a setting I don't know about, or maybe there's something wrong with the headset or the phone? I have tried also switching out the cable thinking that was the problem. Any suggestions appreciated.

1 Reply 1

Sergio Quezada
Level 1
Level 1

I have attached the instructions below. Start your reading at page 16 and you should be good to go.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: