I have recently set up a new SIP provider on a UC560 that requires all numbers be 11-digit numbers starting with a 1. Is there any good way to have an outgoing dial-peer to translate all numbers dialed without 1 to add a 1 and the same time if someone does add a 1 a to the number they are dialing that system will treat it normally?
Basically gain access via CLI
Located the dial-peer, commands as follows when in enable mode
Dial-peer voice XX pots
"XX" is the dial peer number you want to edit.
Let me know if you need additional commands
Sent from Cisco Technical Support iPhone App