Adding 1 to all outgoing calls

[pennautomotive]

I have recently set up a new SIP provider on a UC560 that requires all numbers be 11-digit numbers starting with a 1. Is there any good way to have an outgoing dial-peer to translate all numbers dialed without 1 to add a 1 and the same time if someone does add a 1 a to the number they are dialing that system will treat it normally?

[Mario Garcia]

Via CLI you can in the dial-peer to prefix a 1

Sent from Cisco Technical Support iPhone App

[pennautomotive]

Do you mind providing an example? Even sudo-code would be appreciated.

[Mario Garcia]

Basically gain access via CLI

Located the dial-peer, commands as follows when in enable mode

Conf t

Dial-peer voice XX pots

Prefix 1

End

"XX" is the dial peer number you want to edit.

Let me know if you need additional commands

-Mario

Sent from Cisco Technical Support iPhone App

[pennautomotive]

That's perfect. Thank you very much.

Sent from my iPhone