Voice Systems and Accessories - Small Business

I've got a customer with a Cisco UC540, they also have a Cisco UC540 on another site, that they VPN onto. They are trying to upload custom on hold music, to the site they VPN onto, in the Cisco Configuration Assistant (CCA), I have seen posts and vid...

I have a  SPA504G phone that i have been using then all of a sudden the display screen went blank, the lines that showed green are now off and the following lights have remained on Mute bright red, headset green and speakerphone is also green. Nothin...

Hi everyone, i trying to use a SPA3000 and SPA3102 to make and receive call with PSTN (FXO)It's working fineI have a PSTN Line registered in a SIP serverUser ID: 1001Config a dialplan Dial Plan 1: (<:06732011173>S0) Dial Plan 2: (xx.)And config a VoI...

Hi Everyone, I have a SPA112 and a Iwatsu ix-vta phone. I have SIP all set up and registed, on the SPA112, but the line one status light is constantly flashing. I went here (http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=a3acfa009afd4893ac1257166...

Hi, I have enabled wifi through command line. I see it as hidden network and  could not connect to it. Also, i am not able to get the gui for the Access point. ASA 5506W-X comes with Aironot 702 series AP. And i used the following commands(see attach...

Hi,the Cisco download link for the SPA400 USB module - apparently spa400vm.zip, no longer works. Is there a new location, or can someone reply back with a link to where else I can find this image for the USB  stick?Thanks. Russ.

I have problem with Voice, when I setup default settings of sip registration (UDP, 5060). I heed to setup 5065, TCP. And I haven't found SIP transport in web setting of this VoIP.

Hello everyone, I would report freezing of SPA504G phone when is unable to resolve LDAP server IP address through DNS query. Running firmware is the latest 7.6.1 . This only happens when DNS isn't available. DNS server is down, misconfigured IP addre...

I want to connect two  SPA8000 voip gateways. Is that possible to do? if it is possible how to configure these devices?

Our Telephone MUX failed recently and is unrepairable.  We purchased two SPA8000 Phone Adapters with the intent to connect them by way of a local area network.  We have five analog phone lines to use on ports L1-L5 at the office side of the network a...

Hello everyone. Since upgrading to the latest firmware version 7.5.7 , we have had a few users using the SPA504G report intermittent issues (happens once or twice a week) with their SPA500DS sidecars where their sidecar displaying a BLF list is "froz...

Good Day, I use a SPA122 ATA (in bridge-mode behind a Netgear DGND3800B) for my VoIP comms. The VoIP-evironment is provided by DT Deutsche Telekom in Germany. Voice comms is not a problem. From the analog telephone, that is connected to the ATA (S...