Have recently installed an SPA112 VoIP adapter. It is able to receive calls but cannot send them. Am certain there is something missing in the set-up but not sure what? Any help would be great please.
Hi we have a cisco UC520 I want to configure a voicemail while support extension is not available all incoming calls should be transfered to this announcement also from support poste transfer should be dine by softkey.Thanks
I have a SPA9000 and I'm using two lines (out of four). One from my internet provider, which needs the VOIP wan, and the other from a SIP provide, over the Internet.Also, I have a two WANs router (one for the internet and one for the VOIP). So, If i ...
This is not a new question ... our IT guy as gone and left us without username and password to access the UC 320W andno configuration backup.It's possible to recover the access to the UC320W without loose the present configuration ? I saw that an ans...
Hi,Not sure if this question is right but can I use the SPA112 2-Port Phone Adapter to connect a PSTN line? What I want is, I should be able to choose a line and while making calls. Use PSTN or VOIP. Please let me know if I am using a wrong device...
Hi,I've a SPA8800 registered to SIP proxy provider.I want to know if it possible to forward call from internet port(WAN) to FXO(Line) port. if so, how to do it? Many thanks
Hi,We have an SPA232D which has been set up as per the instructions that came with the device and also found here: http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/csbpvga/spa100-200/quick_start/SPA232D_QSG-en_78-21580-01.pdfI confirm that all ...
Can't pin this one down. uc560, Running: software pack 8.02 - CME 8, CUE 8.06 - yes, I know its old.We added a new 7975, it would not register, discovered that the term75.default.load file had bad info in it and the tftp lines for the 7975 were als...
Hello,I am new to configuring Cisco VoIP, I've read around the forums and I am eager to learn more.I need help on the following situation:Setup:- UC560E1 PBX.- local phones SPA512G and SPA502G on the same subnet as PBX.- branch office phones SPA512G ...
Hi, I have an SPA122 ATA that won't maintain an outgoing call. Incoming calls are fine, just the outgoing calls that get dropped within a minute. This has only been occurring for the last 2 weeks. It was working fine previously. No changes to the equ...
Hi, We do have SPA504G phones on the field. Phones are sending re-register invite after 8 mins passed from a successfull reregistration. Second registration attempt is not in vaild format , hence Softswitch sends 403 forbidden and registeration drops...
I need help with the correct day light savings settings for NSW Australia in the CISCO SPA504G handsets.The current settings are as follows during normal times: Time Zone: GMT = 10:00Ignore DHCP time offset: YES The problem I have is with the dayligh...
I need help with the correct day light savings settings for NSW Australia in the CISCO SPA504G handsets.The current settings are as follows during normal times: Time Zone: GMT = 10:00Ignore DHCP time offset: YES The problem I have is with the dayligh...
Hi all,Don't know if somebody tried it before.One SPA504G, Ext1 configured for using an extension on a foreign PBX, Ext2 configured for using an extension on another foreign PBX.All's working well, by pushing the key i can choose one or the other ext...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: