Voice Systems and Accessories - Small Business

I had to update a voice mail extension for a user in our UC-540 recently, and after completing the update (just changed the name), the AA greeting wouldn't play. I restarted the 540 and when it came back up the greeting was there, but when an extensi...

Have new SPA525G2 phones running 7.5.5.a that I'm adding to existing UC320W system. These phones are constantly resynch/rebooting!!!existing phones running 7.5.2(u2) running with NO issues. Duplicated issue on another UC320W as well as successfully a...

I have a SPA525G that I set up in our office. We run our phone system using 3CX.  After provisioning the phone for my profile, I noticed that the tabs at the bottom of the screen are labeled with the prefix "S_" (eg: S_Redial). I'm not sure what is g...

We have an SPA122 ata that is connected to a modem that the utility company uses to read our utility meter.  I am able to make calls ingoing/outgoing with an analog phone, but when connected to the modem on our utility meter it is not communicating c...

hello i have a problem with an uc560, it was fine until yesterday, but now it does not start telephony aplications at all, all related with telephony does not work. Router related things work, with cca i can't load the configurations, please some bod...

Hello, I have problem with propagation of CFWD setting by soft button to Asterisk 11 PBX. I have set Vertical Service Activation Codes for CFWD, I experimented with Feature Dial Services Code parameter but with no succcess. Setting by star code *72 w...

I have 3 analog phone line. I would like to set up a PBX like system in business to route transfer, auto answer etc. So i did some researching and found Cisco SPA8800. I am hoping just to purchase this device and about 4 to 6 IP (Which i am also look...

Hello all, I have a problem with spa504g. I'm using few spa504g in my office. Computers connected to the network via phones onboard switch. From time to time pc lose the network connection (usially it happened after switching of the ethernet cable fr...

I just bought a SPA112 and set it up for voip.msI've noticed that it's rebooting itself quite often and I have pin pointed one of the cases when it happens and I can reproduce it.1. Dial a voip.ms extension  from the Line1, makes my MicroSIP ring on ...

when resync from http. it always shows:SPA303 ec:e1:a9:cb:15:14 -- Resync failed: http_get failedi can access using web browser. But the phones always got failed.sometimes it takes couple of hours to make it success. does anyone know the possible rea...

In certain situations and timings of SIP traffic to an SPA504G running any released firmware from 7.4.8a to 7.5.6a, the phone enters an endless Ringing state if the following sequence of SIP messages is received and responded to. PBXIP -> PHONE I...

Hi all,we currently have a Cisco UC560-T1E1-K9 with image uc500-advipservicesk9-mz.151-2.T2 running CUE 8.0.3It has also a SIP trunk with another UC540.IP phones are Cisco CP-6921 with old firmware 9.0.2.0Last weeks we had several IP phones losing so...