Hello everyone! I'm creating software for control spa phone: make calls, control calls, viewing incoming, outgoing and etc. One problem, what I'm solution not found is: how get current ringing lines via http request? Maybe exist a method li...
Do any of the SPA50Xg series of phones or SPA122 have any sort of CLI? My googling hasn't found much and telnet to port 23 doesn't work. The web interface has no option to enable this.I guess since they are running some sort of Linux internally there...
I have a customer who wants to not hear the beep when new calls are coming in. They still want the phone to light up and to get CID. I can not find a setting on the phone to disable the beep, any idea which one it is?
We have a scenario where certain SPA112/SPA122's are placed in a specific voice VLAN. For units in this VLAN, we want to change some provisioning parameters, such as SIP registrar, which is only available in the voice VLAN but not from the outside or...
After updating to firmware 1.3.5.004 - the device do not mapp DHCP requests to the connected computer. Thus in IP telephony are registered normally. The device is using as bridge. Has anyone encountered this problem?P.S. We have this bug in several d...
Many of our SPA504g phones have been freezing recently (non responsive to any buttons on the phone or off-hook).They are running 7.5.5b as 7.5.6 has a bug.We have a range of hardware revisions (eg 1.02(0001), 1.04).They are all connected to Cisco CE5...
Hello, i'm trying to setup a SPA504G to make an "On-hook transfer" like i was able to do with the old Cisco IP Phone 7906 or 7911.The transfer i would to do is (part in red):<<Talk to the transfer recipient before transferring a call (consult trans...
I always get the message, when I want to upgrade my WIP310 from 5.0.12 to 5.0.13"DEVICE COULD NOT BE INITIALIZED"Software download is correct, Phone switched-off,using Windows 7.I have tried all, nothing helps.Any idea?
Dear all,I have some issue when I using Cisco Configuration Assistant. The UC 540 has already configured before and all telephony service is running and in production. The system is just hand over to me. Now I am using the Cisco Configuration Assista...
Hello Dear competent Cisco SPA303 phone we have. This phone's LCD screen from the place where the factory settings and network settings section for users want to remove. How should I do a setting from the web interface. Thank you.
We have 2 SPA-112 units (running the latest 1.3.3(015) firmware) which are experiencing loss of registration on a regular basis. The web interface shows that the line is off-hook, and that it is registered. However, there is no dial tone on the li...
This is a bit of a follow-up to the previous post of memory issues w/ the UC540. I had (two weeks ago) changed the Internet connection from a Time Warner with Ubee modem to an AT&T connection with an NVG589.I don't have a UC540 at my office, I use a...
If a client has CMBE6K 9.1 existing, and wants to do an Add-On of 150 Enhanced Users, can I use the “R-UCL-UCM-LIC-K9” for adding these licenses ? I don’t think there will be any issue since CMBE6K is nothing but a regular CUCM but can somebody pleas...
We recently deployed a new UC560 T1 system. Everything is working great, but I cannot get this call connector toolbar to work for the life of me. When the UC560 was in the test environment the call connector toolbar work perfectly fine, now that the ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: