Hello, have a uc540 running 8.62. Have an extension when it's in use, doesn't light the blf on other users phones. IE ext 110 picks up the phone and is in a call. Rest of users on system with a watch mapped to the ext 110 DN, don't see the ext ...
Hello, i have to configure the unit keys of a SPA514G. BLF with other extensions works fine. But how can i use a mobile number? the LED should be green. fnc=sd;sub=mobile_number@10.4.3.253:5060;nme=nameOn the SPA525 this works. But not on the 514G. ...
We have a number of SPA-509G phones with SPA-500DS attendant consoles attached and want to use them on an Asterisk based SIP system. everyone keeps saying that the soft keys on the 500DS should be programmed:fnc=blf+sd+cp;sub=name@$PROXY It doesn't w...
Hi,i have spa504G (sip version)+spa500s and CUCME (cisco 2911, Version 15.1(2)T1).I haven't found any guides about this issue. Is it possible to configure speed dial buttons on spa500S? Thanks a lotAlexander
HiIn the deployment of BE6K cluster consisting of 2 nodes, what are the deployment options available for the Unity Connection applications ? Does BE6K supports the deployment of 2 separate Unity Connection instances (operating independently) ? Is act...
Hi I have a SPA112 with 2 phone numbers on, one for each line, how can I make the calls from both lines ring on fx. Line 1 or both Lines? I have only one phone attached that is the reason. Also is it possible from line 1 to make outgoing calls on Lin...
I have a SPA2102 and it has been working fine until now. I now have a blinking green power LED flashing. I have reset by removing the power cord and I still have the issue. Any recommended fixes? Thanks in advance.
hello, I can not configure 2 SPA3102 gateway model;is a gateway into the A site and I have to use the FXO port to carry an analog line at Site B on the FXS port of the second gateway, but I can not configure the interfaces.can you give me some help, ...
Visiting a client site tomorrow and he is on 7.5.4. He has asked whether 7.5.6 is okay to use. Problem w/ 7.5.4 are some occasional audio problems, which I think are fixed in 7.5.5, but wondering if I shouldn't jump right to 7.5.6. Thanks!
I purchased spa2102 4 days ago but now I can't configure it via a web browser.The status bar info says 'connection limited or no conectivity' so typing 192.168.0.1 gives no result, but the same cable works when plugged to a router.I tried also to co...
I'm trying to recover a SPA502G that was working OK before an attempted firmware upgrade. The recovery.exe (V7.4.4 and V7.5.2b) says "Before proceeding, please confirm that the SPA's Status LED is blinking repeatedly..."My status LEDs do not blink. T...
I bought the SPA112 several days ago and cannot configure it. The issue is that i cannot find a dynamically assigned IP address from ATA.IVR is not connecting , DHCP server is not showing connected device (DHCP server is configured normally, I connec...
Hi,I have a SPA508G that somehow was changed over to SCCP on a different network.I haven't been able to change it back to SIP, and factory resets don't seem to be doing the trick.Is there a specially crafted XML config file I can put on my TFTP serve...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: