Voice Systems and Accessories - Small Business

I have this problem:I tried to upgrade the UC540 by CCA but always failed. after several attempts, I tried to take him by the CCA to default settings and told me to first upgrade the software version UC540 (issue that could not do before).I went to t...

Dear Cisco community,we are using a SIP trunk with 5 DIDs. Is there a way to see the line (DID) that has been called on the display of a SPA 303? We can only see the caller ID (twice, one line with +44 as prefix and a second line with 9xxxx). Routing...

We have some SPA525G2s that are losing registration randomly. They are connected to a UC320 and SG500 Series switches. They're on the correct VLAN and the UC sees the switch as a CDP Neighboor. It's occured both with a hardwired phone and a wireless ...

Good day.Is it possible to reset password on SPA-841. Someone changed old (very simple) password. Looks like that malefactor turned off provisioning and dhcp, so device now is totally unworkable.

Hi I have a TP-Link 24 port PoE switch (TL-SG3424P) which I have connected to a UC320W and 8 x SPA508G Phones. What settings are required for the UC320W to be able to link to the 508G Phones?

Hello!Is it possible to create SPA2102 dialplan with 2 sequential hotline numbers (after offhook, no dialing) (if first is busy, try second)? something like using  Cfwd Busy Act  Code *90, which forwards busy calls to the extension specified after th...

Hi,Hope I'm in the right place!I have owned an SPA3102 for several years. Principally used for dialling out on a standard DECT handset via my VOIP provider. This works well with no issues at all.However, although I do not suffer from echo, I have a p...

Hi,Some of my SPA122 generates 3 Profile requests at about 90 seconds intervals. Others just request the profile once.I assume this is not an ideal situation and would like some understanding or steps to figure out why this is happening.All of my ATA...

Hi all, can someone please assist or advise us with a call quality problem?The UC has two analog trunks connected to two FXO ports, to allow calls to and from the PSTN. They have had various call quality problems since the system was installed 18 mon...

Hello everybody,     this is my first post into the Cisco support forum. I've recently installed a Cisco UC540 with 5 SPA 504G phones to a customer site, but I was unable to configure some (supposed) simple things. The most important is to set up an ...

Hi - we have a client with a Cisco UC 560 and they want the ability to dial *xxx (any three digits after *) and have that translate to an outside line.So basically if I dial *100 it dials 222-1234 for example. *101 dials 1-800-553-2447 for example.Is...