Voice Systems and Accessories - Small Business

I have a SPA112 ATA. This device worked fine until 2 weeks ago I can not get any contact with the incoming calls. Setting outgoing calls goes fine.When an incoming call comes, I see the incoming number, but when I answer te call, the calling party is...

Hello folks,I have noticed people complaining about this issue for several years but I haven't seen any workarounds or solutions even though Cisco has released new firmware versions since this issue has come to light. The SPA does not properly quote ...

Hi all, UC560  is runnig CME 8.6 (uc500-advipservicesk9-mz.151-4.M4b).I only have internal SCCP devices.I have configured presence, allow watch on all dns and blf speed dial command on an SP508 with 500S addon.Well, it works for some hours ( i am try...

Hi,We have setup Jabber on the iPhone on our UC540 and it works well int he office.We have our UC on 192.168.1.5 with its wan port connected to the internet, and SIP trunks coming in for incomin and outgoing calls. with a public IP on the WAN PortOur...

I currently use a UC300, would SPA phones work with the BE3000 and does it support remote phones? 

Morning all.  Hopefully someone here can help me out with this issue.  I am beating my head against the wall.I installed a UC540 for a client.  The implementation has evolved since I first put it in to now include a SG300P and several UC541 AP's.The ...

As part of a recent implementation of a UC540 I am having an issue with several phones that are being migrated over from a previous CUCM deployment.  These are both 7975's and 7970's.The issue with these phones is that they boot up fine, register wit...

Hey.I have a UC320 setup with 4 SPA 303 phones currently, 2 analogue trunks going into the FXO ports (one from my Vonage Box and one from the local telephone exchange) and 1 analogue telephone connected to the FXS port and set up as a PBX System.In t...

Hi, hope someone could help me on this one... We just received a UC560 with 2 cisco phones. One 514G and one 7962. This is just a demo product that cisco sent us so we can try it in our environment and if it does the job then we might purchase multip...

Hi, is possible connect two SPA112 together to get IP bridge of the analog lines? Or some other product? need only 2 lines and not so much expensive. Thanks Jan

my E1 provider wants to see 10 digits from my be 3000, but saw only 4 which is my internal line number.what should i do to send 10 digits???sorry for my stupid question.i'm new in phone tec)))

Does anyone know how to connect a paging system to a FXO port on a UC540?  Configuration?  I know there is something to do with dial peers but I don't know what.