Voice Systems and Accessories - Small Business

I have a UC560 which is in a location (remote site) and I have a PBX in other location (headquarters) The extension of UC560 phones are 3xx y the PBX extensions are 2xx. I have a Gateway which is connected to UC560 via trunk SIP and this gateway is c...

Hello:I just installed SPA 122. For the first time everything was fine but there is no more ringing for incoming call. But the caller listens ringing tone, even it goes to voice message (but message is not recording too). Cahnge a lot of ring voltage...

Hi All,I have been testing some low end phones and I have to say I'm impressed with the SPA303. It works great with my platform (Siemens OpenScape Voice + Xpressions VM) with almost everything working straight out of the box. The only thing that I'm ...

Dear All,We are newbie on Cisco UC560.Our customer use Cisco UC560, ESW-520-24P and Cisco SPA 502G and 508G for their branch office replace old traditional PBX. Cisco UC560 have built-in VIC2-4FXO and VIC2-4FXS. Our customer PSTN line connected to UC...

Installed 3 SPA 504G with 3 different phone lines.Since customer has not got multiple SIP sessions with the provider (Engin) I put 3CX as an IP PBX.I mapped one of each of those numbers to one Ext on the 504's.So one number goes to Ext 1 which shows ...

So I am going to be trying to deploy a UC520 into an existing infrastructure with HP Procurve switches. From what I've read this is a little tricky. Just wondering if someone can give me a heads up on the problems I may encounter. If I plan to have t...

Good morning all, just installed 3 SPA 504G hooked in the office to a 3CX IP PBX.Since the customer has got 3 different phone numbers and the provider did not give them multiple SIP log ins, then the IP PBX (3CX) fixed it.The SPA 504G have been set u...

We are pleased to inform that 8.6.4 Australia & UK are now posted to CCO. URL : http://www.cisco.com/cisco/software/release.html?mdfid=283783671&reltype=all&relind=AVAILABLE&dwnld=true&softwareid=282074333&rellifecycle=&atcFlag=N&release=en_AU-CP-8.6...

I have a UC320 on 2.2.2 and am getting complaints that, when dialling out, the recipient has difficulty hearing the caller. This only happens with calls over SIP and not with calls over FXO. Is anyone aware of any way to raise the gain on the SIP tru...

Hi Friends,We have installed UC560 in our client place......Its configured with AA .......AA is plays for few days and then goes off......But If we restart the PBX its works for some days...and they its again the same.......But the AA file format is ...

I have a wierd issue, where only Vonage calls are having issueWhen someone call from Vonage, it goes to auto attendant, but it doesnt recognize the input. I tried more than 10 times and all call failed giving input.I am sure this is a dtmf issue, but...