We are using SPA5xx phones in a hosted product. We'd like to set up a backup proxy with SRV settings, but we don't want to use DNS. And, we don't want to have to type something likeMY_proxies:SRV=192.168.2.100:5060:p=1:w=50|192.168.2.22:5060:p=2...
Does anyone have "How - To" guides on the UC320. I find the documentation to be very confusing. i am looking for best practices on setting up Auto Attendants with flow charts and examples for simple environements. Anything better than the standard...
Hi Everyone,Cisco UC560 on Software Pack 8.2; I have an issue where I reboot the system, and the time changes back to 2 weeks prior. This could have been around the time that I unboxed this thing and started an upgrade. When it comes up, I can pre...
Hi, I understand there are much more pressing dev issues right now with the UC320, but might I request something to look into for future updates.Not sure if anyone else has this problem, but our employees really dislike the external corporate directo...
Hi All,Is there a Cisco document which states IP VOIP traffic flows on the UC5XX? Voice payload & signaling ideally.. I need to know if direct RTP is used between IPT's and if it can be turned off so that RTP traffic can flow via the PBX for remote w...
HiI have two ISP. I would like to configure the UC540 to handle both the ISP. At present one ISP is connected to the WAN Port. We have converted one of the LAN port into a WAN port and connected it to the second ISP. How do I make 1 VLAN traffic to r...
I am looking for the latest firmware / upgrade tool for the Spirua SPA-841. One of my phones has 0.9.1 and I need something newer so paging works properly. It appears like the existance of the product has been erased. How can I get the latest firm...
I have two used Linksys PAP Ver2 boxes, both show a slow 3 blink power LED with a short delay. Serial numbers are CH911FA06661 and CH911G300823. One has Version 1.00.13 firmware and the other Version 1.00.22. I have tried hardware button resets wi...
hi guys, i did not found a guide yet for the uc540 about connecting a sip trunk to the system.. so im asking it here.Am i suposed to connect the network cable from my sip trunk router into any fastethernet port?if so, how do i tell the uc540 wich por...
dear all i have UC520-32U-8FXO-K9 currently installed in my office with 15 IP phones distributed on internal users , i have five PSTN lines connected to this system , all those lines grouped in one line so any outside person wants to call us he can d...
Hello!I have a UC320 with 6 SPA509G phones connected to it. Every few days the phones continously reboot until the UC320 is reset. I have upgraded the UC320 to the latest firmware and tried different cables/switches.Any thoughts on what other steps...
HiI got a WRP400 running.The Line Status on the site Voice->Status is indicating "Registered". Thus SIP-Account-Settings should be fine.At the WRP400 the green LED Line 1 is lite. There is no dial tone when I un-hook the phone. I tried several phones...
Hi there,We are using a UC540 with 4x ISDN BRI lines. In the past we also used a seperate analog line for our fax. Recently we have conected our fax server to one of the analog ports on the UC540. Since then we have problems with incoming faxes. Unti...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: