I have a customer with a UC320 and SPA 303 phones. It is connected to 4 FXO lines. The 320 is programmed as a PBX. The customer complains that sometimes when she dials 9 to make a call, she gets the message "Forbidden". It will not let her "go ou...
I was informed that there is an issue with connecting these types of connections. Could someone please let me know your experiences.Much appreciated! Thanks
Hi all,I have the exact same problem as described here:https://communities.cisco.com/thread/9965That the phone number is getting ABCD appended at the beginning.All outgoing calls are going through a SIP trunk provider.However, there is no solution po...
Hello,I want to add the page extension in a hunt group, so that when there is an incoming call (pointing to the hunt group) pager system will also sound the incoming bell ringing. Is this possible ? Or if not is there any altrernate solution ?I don't...
Hi there,I have a SPA525G2 I'd like to provision via tftp. But unfortunately it does not work as hoped...I did the following in order to get the provisioning up an running:1. Set up a DHCP server on a 1841:ip dhcp pool Telefon_2 host 172.20.2.5...
Hi,We have just got a UCS560 which apparently has to be configured using CCA otherwise it is not supported and you are unable to get support.Is that correct, there was some suggestion that if you were a CLI expert you could configure thiings using th...
Can anyone confirm if Cisco SPA 504G phones can be configured for extension mobility on a UC560?I found one Q&A that said they can't: http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/phones/ps10499/qa_c67-552214.htmlBut, I would like to get...
I have a customer that is using SIP and can't dial out to 411. When you dial 411, nothing happens. The SIP provider (BroadVox) says its because the dial plan is 10 digits. Does anyone know how to configure the system so it can dial 411?
Hi All,Firstly apologies if i've put this into the wrong section. Secondly thanks in advance for your input.I'll first describe the setup and then what we are trying to achieve. Hopefully someone will be able to help.We have a UC560.Users have an ext...
I have my WRP400 wireless router setup for two wireless SSIDs. The first one is a private network and the second is a free wifi for guests/passers-by. When I look at the DHCP clients list it shows all clients connected, but it does not separ...
Hi Cisco Team,Yet again I am faced with an issue with the emergency number Dial-Plans, on a freshly built system that is used only for building Cisco UC's and Switches, and with a brand new install of CCA 3.1.1 we are again faced with the issue of no...
Is there any documentation on multisite deployments (2-site in this case) with an SA540 in front of the UC500, and a Non-Cisco security appliance in front of the other UC500. Does the multisite tab in CCA even work in this scenario, or is it only me...
Hi,We have been trying to configure our lab UC540 as an internet gateway for devices on the private side of the UC540. We have a simple isolated setup where the UC540 is the only DHCP server and the UC540 has a ADSL modem device connected to the WAN ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: