Is it possible to connect to a 7920 phone (in the cradle with USB enabled) and program it through Cisco Configuration Assistant?If not, what other tool can program it to connect to the UC_520 wireless?
Hi Team,I have deployed a UC-320W in a Doctors surgery, and this morning was hit with an odd problem that I just couldn't work out. This issue is making me feel like a complete noob, it is a pretty straight forward process on the UC-500, but I am cer...
Hi there,Setting up a UC560 Site1 and UC540 Site 2 Multisite setup.Followed the Multisite Manager config, and the multisite status shows as up.I can ping from Data VLAN on Site 1, 192.168.1.1 to data VLAN on Site 2 192.168.20.1 If I make a call from ...
Possibly this is a stupid realization for any of the experts in the telephony industry - but I think the very small business is exactly what it's trying to market to!I have just gone round and round between Tech Support / Pre-Sales support regarding ...
I have a UC320 that we are using for demos. I performed a factory reset on the unit to prepare for a fresh install.Now after logging in with cisco/cisco I am shown the "loading new configuration" however it never goes any further.In capturing packets...
I'm having problems with fax send/receive when SPA2102 is connected via D-link router. Faxes just cannot connect or recognize each-other. No any problems if connected directly to cable modem as a bridge. Voice function works fine no matter how it is ...
HiI Would like to know if it is possible to set up a Softphone outside the network using the configuration i have:I have set up a UC560 which is connected to a managed switch and a SRP527W Router (internet), I know you normally set up a VPN on the UC...
I can't use CCA to talk to our UC540 anymore.Not sure what has changed, haven't done anything with it in a while.CCA is happy talking to other UC boxes at clients, it is just ours.It doesn't even ask for authentication, when you click connect it goes...
Hi,Is it possible to remove the instructions that come at the end of a users greeting message? The instructions that say "leave your message at the tone, when you are finished hang up or press hash/pound for other options"?Thanks.
Hi,Can someone tell me the basic steps needed to get SPA5xx phones registered and working with CME as SIP.From what I know, CME is capable of registering the SPA phones as SIP, but is incapable of creating "spa$PSN.cfg" and "spa$MA.xml" files needed ...
At HQ have an RV220 controling our network and IPSec VPN. We just purcahsed a UC540 so that we can have some employees teleworking. I have the UC540 set to 192.168.10.80 and shut off the DHCP and NAT and locally everything works great. What do I n...
I have just installed a SPA525G2 (firmware 7.4.5 / hardware version 2.0.0) and Im unable to upgrade the firmware. I have tried using both the web interface and using upgrade rule (tftp) using v7.4.6, v7.4.7 and v7.4.8. The web interface reports upgra...
Dear All,I would like create outbound voice translation rule for called number. I want to replace #1 to 91521.The following is my translation rule:Voice translation rule 1Rule 1 /#1/ /91521/user dial: #123457 translate to 9152123457I using test voic...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: