Voice Systems and Accessories - Small Business

I'm having issue registering a 9971 phone on a UC520 running CME 8.6Here are the relevant configs -voice register global mode cme source-address 10.1.1.1 port 5060 max-dn 224 max-pool 56 load 9971 sip9971.9-2-2 load 7971 term71.default authenticate r...

Is it possible to have internal calls ringing all attached phones at the same time, just like it is possible for external calls via trunks and a ring all hunt group?

We have a UC540 in production.  It has been working perfectly for the last couple of years.  We added 3 phones last week that booted normally and we were able to make calls from.  Over the weekend all phones lost registration with the UC and none wil...

Plantronics Voyagre Pro UC V2 (BT300) was paired with my Cicso 525G2 until we did a factory reset on the 525G2 yesterday. The 525G2 is able to find the BT headset but will not accept the pin code 0000 hence unable to "connect" the 2.  Do we need to c...

I'd like to program my SideCar to only be a location for Speed Dial numbers. What's the programming language that I need to be putting into my interface to be able to dial outside of my small business location. I've discovered that putting nme:(inser...

Hello everyone,is it possible to register SPA112 with CUCM 8.6 nodes using SRV records at all?When I indicate IP address of the publisher, SPA112 gets successfully registered. However, when I configure SRV records on my DNS server for two callmanager...

I have 2 different phone models (SPA504G & SPA525G) in use, both on firmware 7.6.2a. My goal is to send text messages with Asterisk (MessageSend) to the phones.This works without any issues, but I also want to clear the messages on the phones (remote...

I have installed the SPA112 ATA Device, upgraded the FirmWare, and carried out the "Quick Setup", and created a SIP Line Extension and DDI in Avaya IP Office.   I now get a UK dialing tone, but when I try to dial out (to any number), from this Device...

Might there be plans in the future for adding iLBC to the supported audio codecs for the SPA122?

I have following issue and could not find any hint on the net: I want to enable FAT (Call forward all service enabled) and FAF (Call forward all service disabled)'via softkey on my SPA5xxG phones, sending the entered number to my PBX AND let the theb...

I have an SPA112 running 1.4.1 (002) Oct 26 2015, and I've got a profile gzipped and encrypted using openssl and served via HTTP. If I encrypt the profile on up-to-date Ubuntu 16.04, OpenSSL 1.0.2g 1 Mar 2016, the ATA can decrypt the file, and the AT...

I wanted to know if it is possible to listen to both way communication going on at the SPA504G phone, by connecting an external speaker(s) to an audio output port available on the phone. If not this phone, is there any SIP phone that can do this ? Th...

Hello, I purchased several devices at the sale: - SIPURA SPA-2100 MAC: 000E08ECF162 S/N: 88012GA65696 - SIPURA SPA-3000 MAC: 000E08CAEE76 S/N: 88012DA04269 Both devices are serviceable. Unfortunately, the previous owner has set a password that does n...

Hello My name is Jonathan Our offices will be closing for the summer holidays and i tried to set up a holiday tab in cca. But when i call i still get the open greeting. I also tried to change the time in cca under the tab device properties // syste...