I can't seem to get into CUE. When I do a "service-mod I 0/0 sess" all that happens is this...UC560#ser i 0/0 sessTrying 10.1.10.2, 2002 ... OpenI can try resetting it, clearing the session and reopening, but it continues to do the same thing. I can'...
Anyone? I am just trying to access TFTP on my UC520 via CCA Exec Commands to copy some ringtone files across...and I am getting this error after using cmd: copy tftp flash. Phones work fine and load fine, so obviously TFTP is working....what the??Tha...
I have been told that the UC500 platform supports extension mobilty, yet no where can I find documentation nor does SMP Pro Support have anything either, Can someone please produce a step by step guide to configure this? I could really market this in...
Hi..I was going through all the discussion and solution and configured my system as below... But when ever I dial the call goes through. I never heard any message/prompt. please can some one have look on config if some thing is wrong..applicationserv...
Upgraded to CCA 3.0 then 8.1 CME. All 7975G phones still at 8.5.3S they do not upgrade to new 8.5.4S load in software pack. Checked files on flash and they are 8.5.4S.
I setup the voicemail boxes and I ended up getting voicemails in there before I remembered to also setup notification by email including attachment. How do I get into them. Also is there a way to set an MWI on the buttons of the phones?UC520 runnin...
Hello Experts,I have to design a VoIP solution for about 30 phones. 12 are in location A, 6 in location B, 5 in Location C, 2 in Location D and about 5 teleworkers (soft phone). The needs are presence and Video for sure. They also want to tie Webex w...
I recently set upa UC520, everything was working fine then the POE function stopped working. I made a configuration change adding a CIPC phone but don't remember making any other mods to the config. Could I have mistakenly shut that function down o...
Hi,I have a Skype SIP trunk configured the trunk is registered and incoming and outgoing calls are functioning. When I press the message button on a phone the phone can not connect to CUE. I did some debugs using the 'debug ccsip massage" command and...
We have an UC 540W and would like to do port forwards3389 to 192.168.10.10 3388 translated thru the router to port 3389 at ip 192.168.10.11Port 25 needs to only allow traffic from network 64.18.0.0-64.18.15.255 (or 64.18.0.0/20) (or 64.18.0.0 mas...
Here's my situation. I would like to make the uc520 forward any calls that come in during night mode to another number. On the prior phone system when someone would dial in during night mode it would say:Please stay on the line to speak with a repres...
They arrive in the SPA8800, four analogue channels and are connected in line and equipment at the other end got a SPA8000 connected to conventional telephone set. I need to configure the equipment so that I can receive and make calls from the telepho...
How can we back up the Voicemail boxes? CUE has a back up option, but I do not know if it is backing up the VM. The configurations goes to 192.168.10.12/cue, so is that located on the PC that has that address?Thanks!Ashish
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: