Voice Systems and Accessories - Small Business

Hi,Hi,I have a UC540 configured with a Skype sip trunk. The trunk is registered with Skype. I'm unable to make outgoing calls. I configured the trunk using the latest version of CCA and followed and updated PDF doc for the Skype config. Incomning cal...

When I did a software upgrade using the CCA, it failed when it was restoring the CUE data.  Afterwards, when you tried to access a mailbox, it acted like all mailboxes were new.  I backed up the system before the upgrade so I did a restore.  It resto...

Using the CCA 2.2.6 , i'm trying to find a way to lock down a phone that is used in an unsupervised area.  Basically it needs to dial 911 for emergencies and if possible enter a PIN to get an outside line.Any suggestions....

We have a customer with a UC520 than randomly rebooted.  It only happened once so far.  Are there any error logs I can check to find out why it rebooted?I noticed the closet that stores the UC520 is pretty hot.  That might be why it rebooted but I ca...

Any information or design guide for new Cisco Smart CallConnector Operator. Is it supported for Callmanager Express?http://www.cisco.com/en/US/prod/collateral/voicesw/ps6882/ps10585/data_sheet_c78-568488.htmlwill it be supported for configuration thr...

After three weeks of brutal agony, a solution....Problem: outbound calls from UC540, all SPA525G2 phones through carrier using Metaswitch failed to pass DTMF to PSTN.Metaswitch published two different config guidelines around the UC500.  The Doc ID 9...

Hi all, hope if you can help me. I have a CME with ios Version 15.1(1)T2, RELEASE SOFTWARE (fc1).I already check everything and I can't find the problem.I have a BRI configuration like this:************************************************************...

Hi,I have UC520. The voicemail is not working. I have upgrade it to ios: uc500-advipservicesk9-mz.150-1.XA3a  and erase uc520's configuration to factory default one nothing changed.I have CCA 2.2(6) and I am always recieving same attached error.When ...

Dear CCA team.! 4 TAC calls and CLI requirements with standard CCA configto make advertised features work! Nothing out of band! 1) When doing a new turn up the wizard will launch in aminimized window on win 7.  Not knowingthe wizard is there and be...

Where is the call park buttton or how is the feature accessed on the SPA525G/2?Thanks,

How can I send a call directly to voicemail from the SPA525G/2?It appears to only allow 3 digit transfers.Thanks,

I can connect to a UC560 with the Cisco VPN client.  I am trying to use a softphone.  On a Windows XP workstation, it works fine.  On a Windows 7 workstation, the VPN connects but the softphone will not register.  I compared the routing tables of bot...