Voice Systems and Accessories - Small Business

Hello and Thanks in advance using spa504g phones with spa500s side car; I want to have the side-car work as per article http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=7aa7fdd7d543437ab12a3dbb0940aebe_Configure_Attendent_Console_Key_LED_Pattern_on...

Hi, How can I block users to lower ringtone volume. Thanks,

I have a UC520 which I'm trying to configure.  We are switching to a new ISP who requires that the WAN (FE 0/0) port be tagged with VLAN 35 and then the PPPOE dialer (Dialer2) connected to VLAN35.  How should I go about setting this up. Thanks!

I have been trying to upgrade my cisco spa 504g iphone firmware from 7.5.7 to 7.6.2. I have been following all the steps in the upgrade process by doing it the TFTP server. The phone seems to be upgrading, but after the process is done the phone is s...

Does anyone have suggestions for configuring a line on this 8 port ATA for faxing?  I have quite a few that can either send or receive and some that won't do anything.  I use 4 ports for phones and 1 port for faxing (Ricoh)......any suggestions/advic...

Hello, I have a Cisco IP Spa504G phone in our upstairs conference room. I am trying to find a way to make it possible to answer a phone call come into a different line on this phone in our conference room. Or make both lines the same. Any ideas? Th...

We just upgraded our internet service to 100mbps but my phone seems to be limiting my service to 25mbps. Via wireless I can get full speed but when using wired through the 525 it gets capped. I believe this has something to do with me using a Mac as ...

Dear, I want to use an SPA232 and SPA302D as a simple PSTN DECT phone. I Don't know whta is the correct PSTN configuration to do. Regards.

Hi, I have a client who strongly requests to have a "redial", "miss", and "answered" soft key on the idle screen of his SPA504g phone. I configured the psk1 option with "miss" and inputted it into the "Idle Key List" via the phone's browser. I also m...

Hello guys, So ran into a situation where i can access my remote UC540 thru CLI all day long but for what ever reason i can't thru CCA.  I thought that both ways shared the same credentials, if this is not the case, is there a way to reset the passw...

I have a UC540 and UC560 PBX. Assuming neither of them has any VWIC cards installed, are either compatible with the 2 VWIC's below on the IOS' below? VWIC3-1MFT-T1/E1 (1-Port 3rd Gen Multiflex Trunk Voice/WAN Int. Card - T1/E1) VWIC3-2MFT-T1/E1 (2-P...

Hi, I am unable to call external with the speed dial, I am able to called the configured number manually. Below is my configuration ephone 6 device-security-mode none ephone-template 16 max-calls-per-button 2 username "user787" password 123456 spee...

Could someone please post an image file for a UC520?  I need a new image file and I can't get access to it since support has ended for the product.  Even though the file is still on the cisco sie, I can't get access to it. The one I am looking at is...