cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
755
Views
0
Helpful
4
Replies
Beginner

BE-3000 Not booting

Have a BE-3000 not booting. When display and keyboard connected no indiction on display. Green Power lamp flashing.

Any thoughts??

Thanks

Paul

Everyone's tags (3)
4 REPLIES 4
Cisco Employee

BE-3000 Not booting

Hi Paul,

If you don't see anything on the connected display after a few moments, the unit would appear to be defective.  Please raise an RMA for replacement.

The normal boot process would typically take 20 minutes - so those of you reading this without access to a monitor, expect to see the system light flash for this duration.  Boot cycle is complete when the system LED is solid green.

Andy

Enthusiast

BE-3000 Not booting

Paul,

I am sure you would have done this, but just checking. Did you push the power lamp? The power lamp doubles as the power button. You need to push it to boot it up.

Highlighted
Beginner

BE-3000 Not booting

Thanks Navin, yes have tried this.

Beginner

BE-3000 Not booting

Hi Andrew

Yes i'm familair with the boot process, we have a LAB system for testing and i have installed a couple of these.

I dont get any display when connected and the power light flashes.

I'm going to arrange for a replacement.

thanks for your response.