cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
638
Views
5
Helpful
1
Replies

C barge Feature

Sblazer614
Beginner
Beginner

I have read the discussions and it appears the Cbarge feature requires a tone when activated.  Is there anyway to utilize this feature without the tone just to listen in to a conversation on another station?

Thanks

1 Reply 1

Davidwagman1
Rising star
Rising star

Hi,

I have it configured on my system without a join tone, and in that regards it is silent. On my system at least, I hear a slight connect as the call is conferenced. Those join tones sound like fire alarms...  The other party will see the barge on their screen though:

To remove the join tones: (please double check your config to make sure profile # and join/leave tone names are what are used in your config)

You may first need to shutdown the dspfarm before you make the change if it is active. This will disconnect any active conferences. Then bring it back up with no shut when you are done. I have included them below, use as necessary. You will need to confirm the the shutdown command with a yes.

config t
dspfarm profile 1 conference 
shut  

no conference-join custom-cptone CCAjointone

no conference-leave custom-cptone CCAleavetonene
no shut

Remeber to test, then save your changes.

Hope that helps.

Best,

David

PS: looks like your question got posted twice, you can delete the duplicate using the action panel on the right hand side.

Please remember to rate helpful resonses and identify correct answers.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers