cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
518
Views
0
Helpful
2
Replies
Highlighted
Beginner

Caller ID showing A0

Hi

I set up A UC520 with the software (8.0) and latest CCA 2.2(5). Calls were routed on FXO port to Co-line and caller ID was shown however after upgrading to the latest firmware (8.1) and software(CCA 3.0) when a call comes in the caller ID shows up as A0 instead of the caller's phone number, I have enabled caller-ID on the FXO port by using CLI however this has not worked. I previously used the following code to enable caller ID on the system :

voice-port 0/1/0
shut
cptone GB
timing sup-disconnect 85
impedance complex3
caller-id enable
caller-id alerting line-reversal
caller-id alerting dsp-pre-allocate
no shut
exit

However this code is not accepted in the new firmware.

Do you have any suggestions?

Regards

Mahesh

Everyone's tags (3)
2 REPLIES 2
Beginner

Re: Caller ID showing A0

Any Update on the Issue mentioned above

Regards

Mahesh

Beginner

Re: Caller ID showing A0

Hi

Reset and retried code and worked - CallerID now working

Regards

Mahesh