01-11-2011 09:12 AM - edited 03-21-2019 03:30 AM
Hi
I set up A UC520 with the software (8.0) and latest CCA 2.2(5). Calls were routed on FXO port to Co-line and caller ID was shown however after upgrading to the latest firmware (8.1) and software(CCA 3.0) when a call comes in the caller ID shows up as A0 instead of the caller's phone number, I have enabled caller-ID on the FXO port by using CLI however this has not worked. I previously used the following code to enable caller ID on the system :
voice-port 0/1/0shutcptone GB timing sup-disconnect 85 impedance complex3caller-id enablecaller-id alerting line-reversal caller-id alerting dsp-pre-allocateno shutexitHowever this code is not accepted in the new firmware.
Do you have any suggestions?
Regards
Mahesh
01-14-2011 06:51 AM
Any Update on the Issue mentioned above
Regards
Mahesh
01-17-2011 06:56 AM
Hi
Reset and retried code and worked - CallerID now working
Regards
Mahesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide